The wrist blood pressure monitor is used for non-invasive measurement and monitoring of adults"" arterial blood pressure. It shows time, date, signal for application error and indicator for low battery. It has 2 memory channels with 60 memories on each channel. Battery is powered with 2x1.5V AAA battery.
Position the cuff onto your left wrist as described in the user manual to carry out the measurement.
Start the measurement process by pressing START/STOP button. After checking the display with all digits lighting up, the monitor will automatically inflate. Following the self-test, during which all display elements briefly appear, the measurement begins. During inflation the device already determines measured values used to estimate the required inflation pressure. If this pressure is insufficient, the device automatically inflates by another 40 mmHg (Real Fuzzy Logic).
Then the pressure in the cuff is slowly released and the pulse is measured.
When the measurement has been completed, the remaining air pressure is released very quickly. The pulse, the systolic and the diastolic blood pressure are displayed.
You can adjust the volume during the announcement by pressing + and -.
You can interrupt measurement at any time by pressing the START/STOP button.
Error message appears if it has not been possible to perform the measurement properly. Observe the section in these instructions on error messages/troubleshooting and repeat the measurement.
The test result is saved automatically.
For detailed instruction, kindly read the manual carefully before use.