Beurer BM58 Blood Pressure Monitor

    Out of stock
    AED310.00
    Overview
    • Upper arm blood pressure monitor
    • Having arrhythmia detection function
    • Large, easy-to-read LCD display
    • Automatic switch-off function
    • 2x60 memory space
    • Upper arm blood pressure monitor
    • Having arrhythmia detection function
    • Large, easy-to-read LCD display
    • Automatic switch-off function
    • 2x60 memory space
    • The upper arm blood pressure monitor is used for non¬invasive measurement and monitoring of adults"" arterial blood pressure.
    • This instrument can identify possible heart rhythm disturbance during measurement and if necessary indicates the measurement
    • Use it to measure your blood pressure quickly and easily
    • Stores the results and displays the progression of readings together with the average
    • Suitable for upper arm circumferences 22-30cm
    • Touch screen display
    • Shows average of all saved measured values and morning and evening blood pressure for the last 7 days
    • Positioning cuff
    • Fit the cuff round your bare left upper arm. Blood circulation in the arm should not be restricted by tight clothing or other objects
    • The cuff should be placed on the upper arm so that the lower edge is 2 to 3 cm above the bend of the elbow and above the artery. The tube should be in line with the centre of the palm. Now tighten the free end of the cuff, but make sure that it is not too tight around the arm and close the hook-and-loop fastener. The cuff should be fastened so that two fingers can fit under the cuff. Now insert the cuff line into the connection for the cuff connector.
    • Rest for approx. 5 minutes before each measurement. Otherwise there may be divergences
    • You can perform the measurement either sitting or lying down. Always make sure that the cuff is on a level with your heart
    • To carry out a blood pressure measurement, make sure you are sitting comfortably with your arms and back leaning on something. Do not cross your legs. Place your feet flat on the ground
    • In order not to distort the result, it is important to keep still during the measurement and not talkMeasuring blood pressure
    • Move the touch screen activation switch to the ON position
    • Put on the cuff as described previously and assume the position in which you want to carry out the measurement
    • Switch on the blood pressure monitor with the START/ STOP button . After the full-screen display, the most recently used user memory appears. To change the user memory, press the MEM button and confirm your selection with the START/STOP button. If no button is pressed, the most recently used user memory is automatically used after 5 seconds
    • Before the measurement, the last saved test result is briefly displayed. If there is no measurement in the memory, the instrument always displays the value
    • The cuff automatically inflates. Cuff air pressure is released slowly. If a tendency towards high blood pressure is already detectable, the cuff is pumped up again and cuff pressure increased further. As soon as a heart rate is detected, the heart rate symbol is displayed
    • Heart rate, systolic and diastolic blood pressure are displayed
    • You can cancel the measurement at any time by pressing the START/STOP button or by pushing the touch screen activation button to OFF
    • Er_ appears if it has not been possible to perform the measurement properly. Observe the section in these instructions on error messages/troubleshooting and repeat the measurement
    • The test result is saved automatically
    More Information
    Width12.5
    Height13
    Length 18
    BrandBeurer
    Pack SpecificationBox
    ManufacturerBeurer
    Write Your Own Review
    You're reviewing:Beurer BM58 Blood Pressure Monitor
    Your Rating